* Guns shown in the pictures may be different from the actual gun fits written under each Fobus model.
About the Holster
LaserTuck is designed for carrying multiple sub-compact single-stack pistols with trigger guard lasers installed - inside your waistband. The holster is built from a flexible back that buffers between pistol & body; a non-collapsing shell that covers the pistol; two belt clips to position the holster at waistband height, with three height positions each, to allow cant adjustment; it has an internal spring for stabilizing the pistol in the holster, and an adjustable stopper to control how deep the pistol sits inside the holster.
The holster is lightweight, fully tuckable, completely washable, ventilated, highly durable, it is contoured for maximum comfort, and divides the pistol weight over a relatively broad area making it extremely convenient for every day concealed carry.
IMPORTANT: The LaserTuck® DOES NOT have a passive retention mechanism. When not wearing the LaserTuck® with a holstered pistol, DO NOT invert the LaserTuck® as your pistol will fall out. RETENTION IS ONLY ATTAINED WHEN THE LASERTUCK® IS PROPERLY WORN ON THE BODY. Refer to INSTRUCTIONS / SAFETY WARNING below for proper use of the LaserTuck® holster.
How to use
Place the holster inside the pants, so that the holster shell is at the same height as your waistband. You may need to completely loosen your belt to do this. Make sure that both holster clips are gripping your belt from the outside, with their lower hooks inserted below the belt. You may move the holster forward and back to find the most convenient position on your waist.
Tighten your belt to a point where you can feel retention when holstering, but the pistol can still be holstered without hitting the holster shell. Important: LaserTuck is a holster designed to accommodate various sub-compact single-stack pistols. It is not designed for a specific pistol but for multiple pistols, and does not have a standard passive retention mechanism holding the pistol. Retention is achieved by pressure of the belt on the holster when on your body; therefore, please refrain from inverting the holster when not on you. Your pistol will fall out.
Holster Material - mold injected Polymers. IWB with surface retention - retention is achieved by the holster firmly gripping the pistol between belt tension on the holster shell on one side, and the flexible holster backing made with mild non-slip surface on the opposite side.